Bar and profile cutting
Linear cutting is one-dimensional: only the length matters. CutGrid uses the width field as that length for bars, tubes and aluminium profiles.
One bar, eight pieces
Stock is a 6000 mm bar. Kerf is 3 mm and end trim is 0. Eight pieces: four legs at 800 mm and four aprons at 600 mm.
The pieces add up to 5600 mm. Eight pieces on one bar need seven saw gaps, 21 mm of blade. 6000 − 5600 − 21 leaves 379 mm as one offcut.
| Part | Length (mm) | Qty |
|---|---|---|
| Leg | 800 | 4 |
| Apron | 600 | 4 |
Layout produced by CutGrid’s optimizer for this example. Coloured blocks are parts, dashed areas are offcuts, and the outer band is trim.
- Leg
- Apron
A frame from 6 m lengths
A welded frame: four posts at 2100 mm, six rails at 1460 mm and four braces at 730 mm, cut from 6000 mm profile with a 3 mm kerf and 10 mm trimmed off each end of the bar to square it.
The pieces total 20,080 mm, which by length alone needs at least 4 bars. CutGrid’s plan uses 4 bars, the minimum. The offcuts add up to 3810 mm and the longest is 1777 mm.
| Part | Length (mm) | Qty |
|---|---|---|
| Post | 2100 | 4 |
| Rail | 1460 | 6 |
| Brace | 730 | 4 |
Layout produced by CutGrid’s optimizer for this example. Coloured blocks are parts, dashed areas are offcuts, and the outer band is trim.
- Post
- Rail
- Brace
How the plan is found
CutGrid fills each bar with the combination of remaining pieces that leaves the smallest offcut, longest pieces first. When the result matches the lower bound, the plan is marked as the fewest bars possible.
The lower bound counts the total length with one kerf per piece, and the pieces too long to share a bar. It is computed when every bar has the same length.
Kerf, trim and mitres
Kerf is lost once per cut between pieces. End trim removes the factory end, which is often out of square or damaged, before the first piece. Mitre cuts take more material than square cuts; add the extra to each piece’s length rather than to the kerf.
Common mistakes
Forgetting the blade on long lists
Twenty cuts at 3 mm are 60 mm, often the difference between a piece fitting and not.
Keeping every offcut
A 200 mm piece of 6 m profile is rarely worth storing. Decide the shortest length you keep and treat the rest as scrap.
Mixing profiles in one list
Different profiles are different stock. Run each profile as its own list.
Questions
- How do I work out how many bars I need?
- Add every piece length plus one kerf per piece, divide by the bar length and round up. That is the minimum; long pieces that cannot share a bar can push the real number higher. CutGrid computes both and shows when the plan reaches the minimum.
- What is the standard length of aluminium or steel profile?
- 6 m is the most common stock length for aluminium extrusions and steel tube in many markets; 6.5 m and 12 m are also common. Use your supplier’s length.
- Can I use bars of different lengths?
- Yes. Add each length to the stock list. The offcuts guide shows a remnant being used to save a full bar.